Estate 8206587 Dokumentacja

MICROWAVE HOOD COMBINATIONINSTALLATION INSTRUCTIONSMICROWAVE HOOD COMBINATION SAFETYThis product is suitable for use above electric or gas cooking pro

10NOTE: If microwave oven does not need to be adjusted, skip steps 7-9.7. If adjustment is required, rotate microwave oven downward. Using 2 or more p

11VENTING DESIGN SPECIFICATIONSThis section is intended for architectural designer and builder/contractor reference only.NOTES: Vent materials needed

Recommended Vent LengthA 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent should be used.The total length of the vent

2INSTALLATION REQUIREMENTSTools and PartsTools NeededGather the required tools and parts before starting installation. Read and follow the instruction

3Installation DimensionsNOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requirements” section.*30" (76.2 cm)

4INSTALLATION INSTRUCTIONSRemove Mounting PlateNOTE: To avoid possible damage to the work surface, cover the work surface.1. Remove any remaining cont

55. Rotate blower motor 180° so that exhaust ports face the back of microwave oven, and lower it back into the microwave oven.6. Reattach blower motor

6Locate Wall Stud(s)NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven.See illustrations in “Possible Wall Stu

7Mark Rear WallThe microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2.1. Using m

8Attach Mounting Plate to WallNOTE: Secure the mounting plate to the wall at both bottom corner holes drilled into the wall studs and/or drywall using

95. Cut the 1¹⁄₂" (3.8 cm) diameter hole at the circular shaded area “G” on the template. This hole is for the power supply cord.NOTE: If upper c