Estate Swing Instrukcja Obsługi Pobierz pdf (Strona 27)

Mounting the Control Board and Box

1. Position your control box on the post of the gate or a near by fence. Remove the rubber cov-

ers on the back of the box to revel the holes marked 1 in the picture. Use these holes to mount

the box and then put the rubber covers over the screw heads to prevent water leakage. For a

dual operator set-up, the control box will be on the same side of the driveway as the master

control arm.

2. Use the knockouts in the bottom of the box to run your wires into the control box. The knock-

outs are multi-sized - purchase water tight connectors to run the wires into the box. The water

tight connectors go in the knockouts on the bottom.

All wires being run to the control board should also be run through water-tight con-

nectors. Connectors are available from most home stores or your Estate Swing

dealer.

If using backup batteries, create holes on the side of the box large enough for your

water tight connectors and run your wires in from the side to make room for the

batteries.

3. To mount the control board, first mount the control board stand in the center of the box using

screw holes marked 2 in the picture.

4. Attach the control board to the control board stand using the holes marked 3 in the picture.

3.1

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Brak uwag

Estate Swing Instrukcja Obsługi Strona 27